Care

You only need to give your sheepskin a vigorous shake to restore its original springy appearance when needed. Merino wool bounces back with ease.

Do not store your sheepskin in a plastic bag for an extended period of time.

How can I clean my sheepskin?

Our first recommendation for best cleaning results is to send it back to the family business that does our tanning. They have been in business since 1954 and will … care for your sheepskin with the experience and attention they are known for.

Bucks County Fur Products Inc

220 1/2 N. Ambler Street (rear)

P.O. Box 204

Quakertown, PA 18951

Phone: 215-536-6614

Email: Buckscofur@comcast.net

A good shake does wonders for your pelt. You can also use a wire brush to loosen any debris before you give it a good shake and hang it to air out. This method rejuvenates the sheepskin as it allows air to flow through the wool fibers. Avoid direct sunlight and never leave it near a source of heat.

To Spot Clean:

Method 1: Use a drop of Eucalan Wool Wash or Kookabura directly on the soiled area and a clean damp cloth. Rub the area. When satisfied, LET THE SPOT DRY COMPLETELY. Once dry, use a wire wool brush to fluff out the fibers and shake. Do not place pelt near heat or sunlight to speed up drying.

Method 2: Make a paste of cool water and cornstarch or potato starch. Apply the paste to the area. LET THE STARCH MIXTURE DRY THOROUGHLY  and then you can brush, shake, or even vacuum away the dried starch. The starch will lift any grease, oil or dirt from the spot. Baking soda works too.

Does that sound like a pain? Like, maybe you are tempted to just throw it in a washer with some Woolite? For the sake of your pelt, your washer and your marriage - don’t do it! Avoid detergent. Avoid heat. Avoid agitation. And if you think you were impatient waiting for a small spot to dry, just see how long it will take to dry an entirely wet sheepskin. Remember direct sunlight and heat are out of the question as they can damage the leather of the pelt.

Hand Washing

If you want to hand wash, a laundry sink or bathtub will work. Use cool to lukewarm water and mix in the suggested amount of sheepskin cleaner. (Eucalan or Kookabura) Submerge the sheepskin into the water. Be gentle and do not agitate too much. Rinse and repeat. Empty the tub and refill with clean cool water. Gently move the pelt around the water to remove the soap and dirt. This may need to be repeated a few times. Once rinsed, gently roll and squeeze out the excess water. Hang the pelt to dry in an area where air can naturally flow in and around it. Avoid direct sunlight and heat. Let the sheepskin dry thoroughly and brush the wool with a wire brush and shake afterwards to restore the fluff.